BLAM RS10.2 (Slim)

BLAM RS10.2 is an updated edition of the previous RS10 model. The very low body, polypropylene cone and top and bottom paddings have been kept unchanged and the filings have been made on the motor side of the speaker. The biggest change is the lower-reaching reproduction of the element, in all different housing options, as well as increased sensitivity (87.7dB)

RS10.2 works in a really small case, so the subwoofer is easy to install in almost any car, where you don't want to sacrifice the entire trunk for a sub box. At its smallest, the element can be installed in a closed case of up to ten liters, which allows the reproduction to go down to 46 hertz (-3dB). The housing can be made very low, because the RS10.2 requires an installation depth of only 66 millimeters!

If you don't want to make the case yourself, Auto-Connect has a ready-made twenty-liter case for this element as well.

• 10″ low body subwoofer
• Impedance: 2ohm
• Power rating RMS / Max: 150W / 300W
• Polypropylene cone
• Playback range: 35 – 500Hz
• Sensitivity: 87.7dB
• Ferrite magnet
• Voice coil: 50mm
• Element outer diameter: 268mm
• Installation hole diameter: 229mm
• Immersion depth: 66mm

Enclosure recommendations (lower limit frequency -3dB in parentheses):

• 10 liters closed (46Hz)
• 20 liters closed (38Hz)
• 30 liters closed (36Hz)