Description
Powerful GAS MAD A2 amplifier collection!
The GAS MAD A2 sits above the popular MAD A1 range, while replacing the previous PRP range of amplifiers.
Even better components have been used in the pre-stages of the new MAD A2 amplifiers, with which the sound quality has been raised to a new level. In addition, the very stylish cooling profile of the amplifier pleases the eye and at the same time ensures that the temperature of the amplifier remains under control, which in turn improves the performance of the amplifier.
Stay cool…
Compared to the more affordable MAD A1 collection, the cooling profile of MAD A2 amplifiers has a larger surface area. In addition, the amplifier's ends have ventilation openings and the amplifier's end profiles are higher than the amplifier's cooling profile, which allows air to circulate under the amplifier as well.
For mids, middles or trebles
The crossover filters of the MAD A2 collection are versatile and you can completely disable the filters and run the elements in a full frequency band, for example with a separate series when you use the separate series' own crossover filters. You can use the MAD A2-85.2 crossover filters as low-pass filters, high-pass filters or bandpass filters, which is the best option for, for example, mids or midranges, in which case you can cut out both the highest and lowest frequencies.
The high-pass filter can be adjusted from 15 to 4000 hertz, the adjustable range for the low-pass filter is 50 to 4000 hertz, and in bandpass mode the adjustment range is 15 to 4000 hertz.
Clip light
Sometimes you have to get the most out of your devices. To make this easier, the amplifier has a clip light. If the signal is distorted by more than one percent, the clip light starts flashing orange. If the distortion becomes greater than this, the amplifier goes into protection mode.
GAS MAD A2 amplifiers contain protection circuits for overload, overheating and short circuit. So you can focus on the most important thing, i.e. rocking the music without worry!!!
MAD A2-85.2 technical data:
- Class AB two-channel amplifier
- 2 x 85W (4ohm)
- 2 x 125W (2ohm)
- 1 x 250W (4ohm bridged)
- Playback range: 10 – 25,000Hz
- High pass filter: 15 – 4000Hz
- Low pass filter: 50 – 4000Hz
- Bandpass filter: 15 – 4000Hz
- Pitch of splitters: 12dB / oct.
- Input sensitivity: 0.5 – 6V
- Damping factor: >130
- RCA input
- Speaker-level input with auto-start: Yes
- RCA output
- Bass EQ: 0 – 12dB @ 45Hz
- Signal to noise ratio: >100dB
- Recommended power cable: 10mm² – 20mm²
- Dimensions: 212 x 208 x 52mm